User's Manual

ADDITIONAL iG3 GATEWAY INFORMATION
Discovering Devices (SLIDE 10)
NOTE: New devices can only be discovered when the gateway has an active Internet
connection (ie, your gateway is connected to the internet).
In order for the gateway to control Xanboo devices such as cameras and
sensors, each device must be registered with the Gateway. The iG3 Gateway
establishes a “secure wireless network” between itself and all discovered Xanboo
devices. The gateway can only control devices that it has discovered. New
devices can be discovered at any time. To discover your devices to the iG3
Gateway, access the Local Gateway Administrative pages by:
A) To Discover new devices, log into the iG3 using XanAssist
B) Click on the DISCOVERY menu option
C) If you have new wired cameras, plug them into the camera ports on the
back of the gateway. These will automatically be discovered.
D) Click the Start Discovery menu item to begin discovery for new wireless
sensors and cameras, simply push the discovery button on the device
while the gateway is in discover mode. Please consult the devices manual
for more detailed instructions for specific devices .
E) As each new device is detected by the gateway, it will be listed in the
browser window. NOTE: This page will refresh every 10 seconds to show
newly discovered devices. You may have to wait for a refresh to see the
device listed
F)
Click on the Stop Discovery menu option when you are finished
discovering all of your devices.
NOTE: The gateway will automatically stop
discovery after 5 minutes or if you browse off the page
G) Your new gateway and devices are now ready to be used.
SET DATE and TIME (SLIDE 5)
To set a new Date or Time for the iG3 Gateway:
A) Log into the iG3 using XanAssist
B) Click on the SYSTEM tab
C) Click on the SET DATE and TIME menu option on the left
D) Choose the correct information
E) Click on SAVE
Your date and time has now been updated