MODEL 283TPD Dual Designer Emitter Twin Plug Blink-IR™ INSTALLATION INSTRUCTIONS o 42777 31552 9
DESCRIPTION The 283TPD “Twin-Plug” Designer Emitter is based on Xantech’s standard 283D Designer Emitter with two 3.5mm Mono-Mini plugs each with ‘diode’ isolation. The twin plug feature allows a single emitter to be shared by two IR sources. For instance, one mouse emitter can now be connected to both an IR receiver and a Xantech Multi-Zone Controller without having to place two emitters on the front of the IR controlled source component.
INSTALLATION ATTACHING THE EMITTERS TO IR SENSOR WINDOWS x Each emitter has a clear adhesive layer on the bottom flat surface of the shell. x Simply peel off the adhesive cover and affix the emitter to the center of the IR sensor window on the controlled component’s front panel. ... IR&Red Light ...... Output ..... - - ~ IR & Red LLght Outpllt (Compound Side) §W~We,./ ~~~-wire / x x x Clear, adheslve l~er. (l{.eplacl;!, if ne~essary, with a snort piece or the 2-sided rape SLJpplied).
INSTALLATION SETUP #1 Home Theater \ Multi-Room Controller The setup below shows two IR signals connected to a single source. This allows the source to be controlled from two areas. One mono plug goes to the connecting block. The other mono plug is connected to the MRC44 Controller.
INSTALLATION SETUP #2 Expanded Multi-Room Controller The setup below shows two MRAUDIO4X4 Controllers connected in Expansion mode. Expansion mode doubles the number of zones while using the same number of sources. The benefit of the 283TPD is that you only need to place one emitter at each source. One mono plug is connected to the ‘master’ controller. The other mono plug is connected to the ‘slave’ controller. This application can apply to the entire product line of Xantech controllers.
Limited Warranty Xantech® warrants its products to be free of defects in materials or workmanship. This is a Limited Lifetime warranty from the date of purchase by the original consumer. Any products returned to Xantech and found to be defective by Xantech within the warranty period will be repaired or replaced, at Xantech’s option, at no charge. Xantech will not be responsible for the actual cost of installation or removal of the product, nor for any incidental or consequential damages.