Conduit Box Owner's Guide ACCB-L, ACCB-L-L1

Mounting
973-0031-01-01 Rev A 2–11
Mounting
The Long AC Conduit Box is designed to mount directly to the AC side of a Sine
Wave Plus inverter. However, the SW Plus inverter can weigh up to 136 pounds
(62 kg). The ACCB-L weighs up to 27 lbs (12.2 kg). Ensure the supporting
surface is strong enough to hold twice the total weight being installed. Remember
to include the weight of any other accessory, such as the DC Conduit Box, when
considering the strength of the supporting surface.
Xantrex provides a steel back plate (XBP) that provides the additional support. A
sheet of 3/4" plywood could also provide adequate support.
Mounting on the Xantrex Back Plate (XBP)
A two-piece, steel back plate is available for providing extra support to the
mounting surface. The back plate comes with mounting hooks that can be
attached to the panel to hang the components on as they’re installed.
To mount the Long AC Conduit Box on the Back Plate (XBP):
1. Install the mounting hook (if used) onto the backplate in the position indicated
in Figure 2-8 for the Long AC Conduit Box. See the XBP Installation
Instructions for details.
2. Mount the backplate to the supporting surface according to the instructions
provided with the XBP Installation Instructions.
Figure 2-8 The Xantrex Back Plate
Mounting Hook
Location for the
ACCB-L
Side View
XBP
Left Side
XBP
Right Side
Pass-thru holes for
conduits running
through the back of
the back plate
Pass-thru holes for
conduits running
through the back of
the back plate
35"
(89 cm)
46"
(117 cm)
Hand Holds
Hand Holds