C-Series Meter power Installation Guide C40R/50 Remote, C40R/100 Remote, DVM/C40 Faceplate

6 975-0123-01-01 Rev A
Amp-Hour Reset and Backlight Button
The amp-hour meter on the faceplate or remote can be reset by two
different methods.
Automatic resetting occurs when the C-Series Multifunction DC
Controller is first connected and activated and each time it’s
disconnected from the battery or the meter cable.
To manually reset the amp-hour meter, press and hold the push-button
on the front of the meter until the display resets.
This button also activates or deactivates the backlight for the LCD when
pressed and released immediately.
LED Status Indicator
The multicolor LED indicates the operating status of the controller. A
color-coded label is included on the cover of the controller explaining
the status LED’s indications. It blinks green, red, or orange depending
on the status of the system. The sequence of the flash also changes
depending on the operation of the controller at that time.
See page 17 for a basic description of these indications.
See the Owner’s Manual for the C-Series Multifunction DC Controller
for a more detailed description of the LED indications.