Battery Status Monitor Operator's Guide TM500A

P/N 973-0012-01-02 Rev. A 05/01

Setting Parameters (continued)

CHARGED Indicator Setup (continued)

The fully-charged voltage parameters are now set. To allow the voltage

only setting to trigger the fully-charged LED, the amperage setting must be

switched OFF.

Step B Switching OFF the Amperage Detection

1B. Press the SELECT button until the Amperage LED (

) is illuminated.

2B. Press the SELECT and RESET buttons simulataniously until the LED

display flashes.

3B. Press the RESET button until the display indicates OFF.

4B. Press SELECT button to accept.

The TM500A is now setup to trigger the CHARGED indicator LED ( )

when the voltage level equals or exceeds the value programmed in Step A.

When this voltage parameter is met, the CHARGED indicator LED flashes

approximately every four seconds.

NOTE: The CHARGED indicator remains ON (solid) even when the

batteries are discharging, until reset.

Figure 3-5

Setting the CHARGED Indicator Voltage Level

Figure 3-6

Turn Amps OFF for VOLTAGE ONLY Detection

14.4

Set Voltage Level

Voltage LED

Illuminates to Indicate

the Voltage Function

is Selected

OFF

Set Amps to

OFF

Amperage LED

Illuminates to Indicate

the Amperage

Function is Selected

3.0 CONFIGURATION