User's Manual

5. Place the black ring connector on the black (negative –)

DC terminal, and then screw the black nut on until it is

snug. Do not over tighten.

Note: A spark may occur when you make this

connection. This is normal.

6. Check that both clips are securely connected to the

battery terminals. A loose connection will cause

excessive voltage drop and may cause the cables to

overheat. This could result in equipment damage or fire.

7. Turn on the On/Standby switch. The green

PWR

light

comes on, and AC power is available at the outlet.

Hardwiring the Inverter to the Battery

Loads of any size (up to 300 watts continuous power)

For a

permanent electrical connection, or when you need to power

some loads that are greater than 150 watts and some that are

less than 150 watts, you can hardwire the inverter to the

battery. This eliminates the need to switch between the

battery clip wire assembly and the cigarette plug wire

assembly. A hardwired installation is illustrated in Figure 6.

Warning!

Shock and fire hazard.

Use a qualified installer to perform a hardwired

connection.