Xantrex Rigid Solar Kit Owner Guide

Installation Tips
Figure 3 Applying
peel and stick
panels
1. Peel off the
adhesive cover
from the back of
the module
carefully.
2. Use a 3" roller
(not included) to
firmly bond the
panel to the roof
surface.
3. Use a 2" wide
protective tape
(recommended
3M™ Extreme
Sealing Tape, not
included) around
the edges of the
solar panel.
requires
72 hour
curing
peel off
peel off
peel off
1
2
3
Figure 4 Panel
positions and
cable
management
TIP: Avoid placing
the cable towards
the front of the
vehicle. Protect
cables from any
damage through
friction or stress.
TIP: Protect
connectors from
humidity as much as
possible. Place
them directly
beneath a covering
when possible. Do
not let them hang
loose or be moved
around by wind.
When securing
connectors with
fasteners, secure
the cable instead of
the connector.
to cable entry point
to cable entry point
Figure 5 Cable
bends and
connections
TIP: Avoid sharp
bends when routing
cables. Follow the
bending radius
recommendation on
the right. This
applies to
connections to the
charge controller
and battery.
TIP: You should
hear a click when
the connectors are
attached correctly.
Use only the
supplied connector
assembly tool to
detach connectors
from each other.
60mm
30mm
click
insert the prongs into the slots
10 ©2019 975-0808-01-01 Rev D
March 2019