Manual

Introduction

1–16 975-0401-01-01

• Limit the maximum charger output current (20, 40, 60,

80, and 100% of charger rating) to lower the current

drawn from the generator or AC source

• Set the charger to

ON or on STANDBY

• Set or cancel an equalization cycle

• Display faults and warnings

• Display basic battery level and settings

Item Description

ON/STANDBY Button

• Press to enable or disable the charger while AC power is

connected.

• When in Setup Mode: Press to select the Charger Mode: two or

three-stage.

• To set or cancel an Equalization program: Press and hold both the

Status and

ON/STANDBY buttons for more than five seconds.

2 Charging Output (%) LEDs

• The LEDs illuminate a progress bar displaying the present total

output charge current as a percentage of the maximum charge

current. The numbers below the LEDs represent the percentage

values. See 2a on Figure 1-7 on page 1–15.

NOTE: The charger maximum current can be set using the Remote

Panel.

• An LED may flash intermittently in combination with a solid Fault

LED to indicate a fault or with a flashing Fault LED to indicate a

warning condition. The icons on the right side of the LEDs

represent different types of faults and warnings. See 6a on Figure

1-7 on page 1–15.

TC2 Series BattChg Owners Guide.book Page 16 Tuesday, July 1, 2008 11:55 PM