Product Manual
Table Of Contents
- Important Safety Instructions
- Introduction
- Installation Information
- About the Xanbus System
- Planning the Installation
- Planning Preparations
- Installing the Inverter/Charger
- Overview
- Step 1: Choosing a Location for the Inverter/Charger
- Step 2: Mounting the Inverter/Charger
- Step 3: Connecting the AC Input and AC Output Wires
- Step 4: Connecting the DC Cables
- Step 5: Connecting the Battery Temperature Sensor (BTS)
- Step 6: Connecting to the Network
- Step 7: Performing Checks Prior to Initial Start-Up
- Step 8: Testing Your Installation
- Stacking Features
- Inverter/Charger Physical Specifications
- Battery Information
- Battery Cabling and Hook-up Configurations
- Specifications
- Inverter Drip Shield Installation
975-0697-01-01 21
Installing the Inverter/Charger
This guide for use by qualified personnel only.
Figure 5 Mounting Orientations
Orientation
Approved Mounting
Orientation? Comment
Desktop Mount A - Yes
B - Yes when used with
inverter drip shield
(PN: 808-9004) for
marine installations.
A - Suitable only for non-marine
applications with no risk of condensation or
dripping water.
B - The drip shield is installed on top of the
inverter with some clearance. See “Drip
Shield Placement (Desktop Mount)” on
page 64.
Upside-down Mount Yes (for non-marine
applications only)
Suitable only for non-marine applications
with no risk of condensation or dripping
water.
FREEDOM SW 3000
Inverter
Reset Enable
Inverter AC/
On Charge Fault
Xanbus Interface
FREEDOM SW 3000
Inverter
Reset Enable
Inverter AC/
On Charge Fault
Xanbus Interface
A
B
FREEDOM SW 3000
Inverter
Reset Enable
Inverter AC/
On Charge Fault
Xanbus Interface
Freedom SW 3K2K 230V InvChg Install Guide.book Page 21 Friday, June 20, 2014 9:11 AM