Freedom XC PRO Marine Owners Guide
Table Of Contents
- Important Safety Instructions
- Introduction
- Features
- Installation
- Before You Begin the Installation
- Installation Codes
- Basic Installation Procedures
- Step 1: Designing the Installation
- Step 2: Choosing a Location for the Unit
- Step 3: Mounting the Unit
- Step 4: Connecting the AC Input Wires
- Step 5: Connecting AC Output to an Existing AC Circuit
- Step 6: Connecting the DC Cables
- Step 7: Connecting to Port(s) on the Freedom XC PRO
- Step 8: Testing Your Installation
- Marine Installation
- Operation
- Routine Maintenance
- Troubleshooting
- Specifications
Basic Installation Procedures
32 Freedom XC PRO Owner's Guide
NOTICE
EQUIPMENT DAMAGE
n Do not connect any AC source (such as a generator or
utility power) to the AC output wiring of the Freedom XC
PRO.
n The Freedom XC PRO will not operate if its output is
connected to AC voltage from a source, and potentially
hazardous or damaging conditions may occur. These
conditions can occur even if the inverter/charger is off.
Failure to follow these instructions can result in equipment
damage.
Do not connect the Freedom XC PRO to an AC branch circuit that
has high-power consumption loads that exceed its output wattage
rating.
The Freedom XC PRO will not operate electric heaters, air
conditioners, stoves, and other electrical appliances that
consume more than its rated output wattage.
AC Output Connections
Figure 11 Routing and connecting the AC output wires
N
L
G
N LG N LG
2
1
3
4
5
1 step 7a
2 step 7b
3 step 7c
4 15mm
5 to circuit breaker
NOTE: AC Output hole - install a bushing (supplied) or a strain-relief device.
To make a permanent connection to existing AC wiring:
1. Ensure AC and DC power sources are turned off, if not
already done from AC Output Connections on page 32.
2. Install the required circuit breaker in the inverter/charger
distribution panel receiving AC power from the
inverter/charger.