BLE Module Quickstart Guide

DANGER
RISK OF ELECTRIC SHOCK AND EQUIPMENT DAMAGE
•Connect only to Safety Extra Low Voltage (SELV) circuits and power sources.
•Do not expose the BLE Module to rain, snow, spray, or bilge water. For indoor use only.
•Do not disassemble. No user serviceable parts inside.
•Do not install and/or operate in compartments containing flammable materials or in locations that require ignition-protected equipment.
Failure to follow these instructions will result in physical injury and/or equipment damage.
Exclusion for Documentation
UNLESS SPECIFICALLY AGREED TO IN WRITING, SELLER (A) MAKES NO WARRANTY AS TO THE ACCURACY, SUFFICIENCY OR
SUITABILITY OF ANY TECHNICAL OR OTHER INFORMATION PROVIDED IN ITS MANUALS OR OTHER DOCUMENTATION; (B)
ASSUMES NO RESPONSIBILITY OR LIABILITY FOR LOSSES, DAMAGES, COSTS OR EXPENSES, WHETHER SPECIAL, DIRECT,
INDIRECT, CONSEQUENTIAL OR INCIDENTAL, WHICH MIGHT ARISE OUT OF THE USE OF SUCH INFORMATION. THE USE OF ANY
SUCH INFORMATION WILL BE ENTIRELY AT THE USER’S RISK; AND (C) REMINDS YOU THAT IF THIS MANUAL IS IN ANY
LANGUAGE OTHER THAN ENGLISH, ALTHOUGH STEPS HAVE BEEN TAKEN TO MAINTAIN THE ACCURACY OF THE TRANSLATION,
THE ACCURACY CANNOT BE GUARANTEED. APPROVED CONTENT IS CONTAINED WITH THE ENGLISH LANGUAGE VERSION
WHICH IS POSTED AT HTTP://WWW.XANTREX.COM.
NOTE: Visit http://www.xantrex.com, select PRODUCTS, select a Product category, select a Product, select DOWNLOADS, and choose a
document from the list that may provide a translation of the English guide, if available.
Contact Information
Telephone: [phone]
Email: [e-mail],
http://www.xantrex.com/power-products-support/
Web: http://www.xantrex.com
1
Introduction
The Xantrex BLE Module is a communications accessory from Xantrex that enables a Xantrex
XPLOREcharger to be monitored or controlled wirelessly using a smart device such as mobile phone.
A B
C
A
Xantrex BLE Module
C
Quickstart Guide, mounting tape and four
screws
B
25-ft RJ-12 6-conductor communication
cable
NOTE: If any of the items are missing, contact your
Xantrex dealer.
ISED Notice / Avis d'ISDE
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, S cience andEconomic Development's license-exempt RSS(s). Operation is subject to the following two conditions: (1)this device may not cause interference. and (2) this device must accept any
interference. Including interference that may cause undesired operationof the device.
L'émetteur/récepteur exempt de license contenu dans le présent appareil est conforme aux CNR d’Innovation, S ciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas
produirede brouillage; (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettrele fonctionnement.
RF Exposure
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure conditionwithout restriction.
L’appareil a été évalué pour répondre aux exigences générales d’exposition aux RF. Ledispositif peut être utilisé dans des conditions d’exposition portatives sans restriction.
2
Mounting
IP20
-4
122
-20
50
ºF ºC
SELV
FCC Notice
This Clas s B digital de vic e c om pl ies with Part 15B of the FCCa nd ICES-003 of the ISED Canada Rules . Operatio n is s ubjec t to the foll owing two condi ti ons:
(1) This dev ice m ay not c aus e harm ful interferenc e.
(2) This dev ice m ust ac c ep t any i nterferenc e rec ei ved, i nc l uding interferenc e that may caus e un desired operatio n.
NO TE: This e quipment has been tes te d and fo und to comply wi th the limi ts for a Clas s B d igital dev ice, pursuant to Part 15B of th e FCC and ICES-003 of the ISED Canada Rule s. Th es e lim its are designed to provide reas onable protec ti on agai ns t harmful interferenc e in a resi dential installa tion. This
equipment ge nerates, us es, an d ca n radi ate radio frequenc y e nergy an d, if not instal le d and used in acc ordance wi th the i ns tructions , may caus e ha rmful interference to rad io c om munic ations . Howeve r, there i s no guarantee that i nterferenc e wil l no t occur i n a parti c ul ar ins tallation. If thi s equi pm en t does
caus e ha rmfu l interference to radio or televis ion rec eption, whic h can be determin ed by turni ng the equipme nt off an d on, the user i s enc ouraged to try to correct the interfe renc e by one or more o f the fol lowing measures :
- Reorie nt or relocate the receiv i ng antenna.
- Increas e the s ep aration between th e equ ip ment and receive r.
- Conne ct the equ ipment into an outl et on a circ ui t different from that to which the receiver i s c onnected.
- Cons ul t the dealer or an experience d radi o/TV tec hnic i an for help.
WARNING : Changes or modifi c ations not ex press l y ap proved by the party resp onsible for c om pl ianc e c ould v oi d the use r's authority to operate the equi pm ent.
CAN ICES-3(B) / NMB-3(B)
FCC ID: 2A25 B-XBLEM-BT
IC: 23407-XBLEMBT
975-1040-01-01 Rev B
October 2021
©2021 Trademarks are owned by Xantrex LLC and its affiliates. All other trademarks are owned by
their respective companies.
Xantrex BLE Module Quickstart Guide
PN:808-0889 http://www.xantrex.com