User's Manual

Using XPower Powerpack for the First Time
975-0057-01-01 3-3
Using XPower Powerpack for the First Time
n
Recharging with the AC Charger
Recharging with the AC Charger is a true “plug-in-and-
forget” charging method. We recommend leaving the AC
Charger connected when the XPower Powerpack is not in
use.
To recharge with the AC Charger:
1. Disconnect any 12 V DC appliances and turn the light
off.
2. Turn the AC Outlet On/Off switch to Off.
3. Plug the AC Charger into a standard AC wall outlet.
4. Insert the AC Charger cable end into the Charger Input
Socket located in the storage compartment of the unit.
The green Charging Status light changes from flashing to
steady when charging is complete (about 35 hours if the
battery is completely discharged).
Important: Prior to operating your AC appliance or 12 V
DC appliance, ensure that the battery of the XPower
Powerpack is fully charged. If the battery has been fully
discharged, recharging with the AC Charger may take up to
35 hours.
Note: The Battery Charge (%) reading on the digital
display is only accurate when the XPower Powerpack has
been disconnected from all appliances and all charging
sources for fifteen minutes.
XPower 400 Powerpack Plus.book Page 3 Thursday, October 20, 2005 12:58 PM