PH1800 Install Guide
Installation
3–12 975-0289-01-01
Removing the Factory-installed AC Cord and Knockouts
DC Input (80 A DC Input/100 A fused) Manufacturer’s recommendation. 20.3 Nm (180 in-lbs)
DC Ground Manufacturer’s recommendation. 20.3 Nm (180 in-lbs)
System Ground #3 AWG
Figure 3-10
Removing the AC Cord
Table 3-1
Recommended Wire Gauges for Input and Output Terminals
Terminal Acceptable Wire Gauge Torque to.....
1. Locate the AC wiring from the
cord and loosen the screws on
the Ground, Line 1 (L1), and
Neutral terminals.
2. Remove the 3 #6-32
Phillips screws on the AC
cord access plate and
remove the plate along
with the cord.
Proceed to Figure 3-11.
975-0289-01-01(PowerHub_1800_IG).book Page 12 Thursday, June 4, 2015 9:49 AM