User manual

SaLut


group of 8-bit signal processing devices offering
comprehensive digital signal manipulation, as well
as audio signal, control voltage, trigger, and gate
generation. Drezno is the input/output front-end
of the system, consisting of an analog–to–digital
-

analog signals and voltages based on their binary
    

  
bits of the digital signal representation.
INStaLLatION
-
   
be plugged into the bus board, paying close atten-

the negative 12V rail and should align with the dot,
–12V, or red stripe marks on both the unit and
  
reversed power connection, however reversing the
16-pin header may cause serious damage to oth-
er components of your system by short-circuiting the

 
Lipsk or more expansion modules to form an out-

      -
-
-

should be fastened by mounting the supplied screws
-
vices, we strongly advise the user to read through the
entire manual before using the modules.
bINaRy cODE
      -
   


N-1


0



an 8-bit system, there are 256 possible values, from
      


value is in the top or bottom half of the range, and

         
system, the individual bits are represented as gate
      -
coming analog voltage is converted into eight gates.
DREZNO cONtROLS aND OPERatION


ADC input
1
expects either audio or CV signals.

2
, represent-
ing each of the eight bits, 7 to 0
gain
3
and offset
4
sliders allow the user to
adapt the range of the signal fed to the A/D con-

      
expects only positive voltages, so for bipolar input
signals, set the offset slider to the upper position.


adc clock input
5
allows
the user to override the internal clock by freezing
the output code at the rising edge of the input sig-

the adc clock allows the user to control the ADC
sampling rate. ADC output activity is indicated by
the corresponding set of eight yellow LEDs
12
.

eight DAC gate inputs
6
, representing each of the
eight bits numbered from 7 to 0dac output
7
produces a CV or audio signal based on the input
dac clock input
8
expects gate/trigger
signals and is normalized to the ADC clock via the
ribbon cable connected to the expander sockets on
 
clock can be replaced by a clock produced by an ex-
pander module, and it can be overridden by any sig-

also features gain
9
and offset
10
sliders which
2
modules
explained