User manual
3
INSTALLATION & SETUP
in the Eurorack cabinet. Always turn the pow-
board using the supplied ribbon cable. Pay
close attention to power cable pinout and ori-
entation. The red stripe indicates the negative
–12V
on both the bus board and the unit. Moskwa is
internally secured against reversed power con-
may cause serious damage -
circuit the +12V and +5V power lines. Always
pay particularly close attention to the proper
orientation of your ribbon cable on both sides!
Do not attach the power ribbon cable to the
Ostankino expander connector! connecting
the power cable to an incorrect head-
er will destroy your module! The unit
screws before powering up. To better under-
PANEL OVERVIEW
Moskwa’s panel is divided into four function-
al sections with a row of inputs/outputs at
transport button
1
surrounded by three
red knobs. The button starts and pauses the
rate
2
When an external clock is patched into the ext
clock input
3
rate knob allows for di-
range
4
the cv out output
5
The inner ring around the range knob indi-
reset sets
6
-
-
3 5 74 6 8
step: on,
pattern: four steps,
div mode, gate: half
step: on,
pattern: off,
gate: merge,
glide eefect: slew
limiter active on step
step: on,
pattern: off,
gate: half
step: on,
pattern: off,
gate: trig
step: off step: off