User manual
by pressing the shift/custom button. You
can add steps during playback by pressing and
holding the shift/custom
choosing steps to be added at the end of the cus-
tom sequence. When the custom sequence is
inactive adding new steps erases the previous
custom sequence. To erase the custom se-
quence
press transport + shift.
PRESETS
Pressing and holding the patt/preset but-
the patt/preset button. There are 8 preset
slots available. A written slot is indicated by a
corresponding step button. Upon loading the
-
-
ed preset is indicated by a red backlight on the
corresponding step/slot. Patterns saved while
two Moskwa II units were chained together
(see: below) are indicated by a yellow back-
light. Loading such a chained pattern switches
To write a new preset (saving the current state
pressing and holding the patt/preset but-
ton for one second. Press and hold the shift
you want to assign the preset. All settings are
written along with the preset except for the cv
lock
values set by the knobs and the actual values gen-
erated by the loaded preset. To avoid unexpect-
value written with the preset. To recall the cur-
TRANSPORT BUTTON:
SECONDARY FUNCTIONS
The transport button can be used to restore
-
vidual sequence step 1-8
step and patt. In step mode
transport + step 1-8 resets all settings for
transport + step re-
step mode (includ-
ing the deactivation of steps). In pattern mode,
transport + step 1-8 clears the pattern for
transport + patt re-
pattern mode. In pre-
set mode, transport + step 1-8 clears the
chosen preset slot.
With step 3 active in the global settings
transport button
and turning the probability knob all the way
clockwise and then all the way counterclockwise
clears the probability sequence (see: below).
In step mode, press transport + shift/cus-
tom to erase the custom sequence.
STEP SETTINGS
while pressing each additional step to be edit-
ed. The chosen steps light up green. The step
1-8 buttons are used to select various functions
-
ed its button lights up green.
step 1 • slew on button activates/deactivates
the slew knob.
step 2 • slew prob button activates/deacti-
vates the probability of the inversion of the slew
7