POCZDAM THE LEIBNIZ BINARY SUBSYSTEM leibniz device komutator operator’s manual rev. 1989/X3/1.
module explained SALUT Besides power, you need to connect Poczdam to other components of your Leibniz subsystem. Poczdam comes with three ribbon data cables with 10-pin plugs on both ends. Before installing the data cables, we advise you to read the entire manual and carefully plan your Leibniz setup. Pay attention to the proper orientation of the red stripe with pin #1 indicated by a dot or an arrow on each module.
front panel overview fig.
the data bits, the clock of the selected source is also available in the jack labeled incoming clock out 4 . gate signal. The selected data with its clock is directly fed to the Leibniz out1 header at the back. It is also delivered as 5V gate signals to the bit output jacks on the front panel. Next to the bit outputs is a bank of eight bit outgoing data inputs 5 . Signals connected there are converted to Leibniz data and delivered to the out 2 header at the back.
block diagram Erfurt with Poczdam plugged into its input allows one to select the source of the phase increment. For example, plug Drezno to in1 of Poczdam and Lipsk or Gera to in2. This setup can easily go into crazy territory if you use one of the bit outputs of Erfurt for switching sources in Poczdam. data sequences but with a radically different Use Poczdam to create a temporary loop. For example, plug Erfurt into the Poczdam in1 and the Poczdam out2 into the input of Jena.
MAIN FEATURES WARRANTY TERMS XAOC DEVICES WARRANTS THIS PRODUCT TO BE FREE OF DEFECTS IN MATERIALS OR WORKMANSHIP AND TO CONFORM WITH THE SPECIFICATIONS AT THE TIME OF SHIPMENT FOR ONE YEAR FROM THE DATE OF PURCHASE. DURING THAT PERIOD, ANY MALFUNCTIONING OR DAMAGED UNITS WILL BE REPAIRED, SERVICED, AND CALIBRATED ON A RETURN-TO-FACTORY BASIS.
