User manual

5
cv
asignment
Press the sus/level encoder
D
to toggle be-
tween sustain and level parameters. The
sustain sets the point on the envelope to be
held whenever a gate signal fed into trig input
is high. The position is indicated with a vertical
dashed line. note: to disable the sustain stage,
simply move the sustain point to the very end of
the envelope until the display reads off.
The level parameter serves as an attenuator
to the envelope amplitude, from 10V down to
10mV (and 0). The approximate value is dis-
played as a percentage of the entire voltage
range, and the exact value in volts is visible
during adjustment.
menu: cV AssiGnments
The central, red–illuminated menu button
6
cycles through three menu pages: CV input
assignments, chain/loop settings, and preset
management. note: with the Nin expander
module installed, a secondary CV assignments
page appears that addresses the extra set of
asgn inputs on the expander. note: encoders
      
pages than in the top, default screen. Within
these pages, encoders correspond to separate
channels, and not the default parameters indi-
cated on the panel.

the corresponding channel's encoder to set its
CV destination. The list of available parameters
is browsed in a loop:
shp — selects the envelope shape
tim — adjusts duration
wrp — adjusts temporal warp
rsp — adjusts response
lvl — adjusts amplitude level
rep — selects the number of repeats
phs — adjusts phase shift
rev — reverses the shape
sus — sets the position of the sustain point
frz — freezes the envelope state
The degree of CV control of the selected param-
eter can be set by turning the encoder and is
indicated by bipolar percentage bars with 0V
in the middle. The interpretation of the display
is straightforward — the higher the bar is dis-

the parameter value. note: sensitivity of -50
for the time parameter offers an approximate
1V/octave response. Also, the rev and frz pa-
rameters react to CV in a binary manner. Like a
comparator, the respective action is performed
when the input CV exceeds the value as indi-
cated by the bar. With rev, the envelope is re-
versed in relation to the current panel setting,
and with frz, its state is frozen, thus pausing
cv asignment menu
main screen