User manual

16
Cleaning and Disposal of Devices
To clean the Wireless Radiator Controller/Timer,
useonly adry or lightly damp cloth. Avoid chemical
solvents, as these may damage the device.
Adapters
Heimeier,Junkers Landys+Gyr,
MNG, Honeywell Braukmann
M30 x1.5 thread
No adapter
required
Danfoss RAV(included pin
must be inserted into valve
tappet)
+included pin,
only for RAV
Danfoss RA
Danfoss RAVL
Please completely remove all connecting pieces on
the plastic adapters beforeusing any of the included
adapters.
Completely remove the connecting rods marked in
grey beforeinstalling the adapters.
Help
Problem Cause Solution
Batteries nearly
dead.
Replace the batteries.
Radiator
will not
heat up.
Water tempera-
tureinboiler
okay? Valve will
not open after
heat was off for
the summer
–limescale
build-up?
Correct temperatureofwa-
ter in boiler.Disassemble
the Radiator Controller.
Move valve tappet back
and forth multiple times by
hand or with atool.
Radiator
will not
cool down
Valve is not clo-
sing completely.
The point where
your valve seal
closes may have
shifted.
Carry out adaptation again
(see “Adaptation”). Move
valve tappet multiple times
by hand –adaptation may
not be possible because
your valve may have
limescale build-up or the
seal may no longer be
functioning.
Compres-
sion piece
fell out.
(Thiscan
alsocause
an E1
error.)
Becausethe
device hasan
endless screw,
thecompression
pieceonthe
bottom can
fall outifthe
controller is not
mountedonthe
valve.
Insert the compression
piece. Start the adaptation
process using the
MENU
item or by removing and
reinserting the batteries.
The endless screw rotates
and tightens the compres-
sion piece again. Mount
device on radiator and
perform adaptation again.
-
Pressing any button deletes the error shown
on the display and starts the adaptation
process again.
Adaptation not
possible. The
Wireless Radiator
Controller/Timer
not mounted on
radiator.
Device correctly mounted
on radiator? Mount the
Wireless Radiator Control-
ler/Timer.
Valve stroke too
short or battery
power too weak.
Open and close valve tap-
pet multiple times by hand
or insert new batteries.
Valve will not
move.
Can the valve tappet move
freely?