User's Manual

AR396 User’s Guide
20
MAC Encapsulation Routing (MER)
Figure 22: WAN Connection, MER Configuration
To configure the IP over Ethernet settings:
 Select “Obtain an IP address automatically” or “Use the following (fixed) IP address” and
then also enter the WAN IP address and WAN Subnet Mask.
 Select “Obtain default gateway automatically” or “Use the following default gateway” and
then also enter the gateway IP address and Use WAN Interface where packets will be
sent to.
 Select “Obtain DNS server address automatically” or “Use the following DNS server
addresses” and then also enter the IP addresses of Primary DNS server and Secondary
DNS server.
 Click Next to set the NAT, IGMP multicast and MAC Clone settings, please refer above
descriptions in PPPoE configuration for details.
The page of Network Address translation (NAT), IGMP multicast and MAC Clone settings will
show up and then WAN Setup Summary page will show up. Please refer related pages above
for reference. Click Save if correct and click Back to restart the configuration again.