User's Manual

AR396 User’s Guide
21
IP over ATM (IPoA)
Figure 23: WAN Connection, MER Configuration
To configure the IP over Ethernet settings:
 Enter the WAN IP address and WAN Subnet Mask.
 Select “Use the following default gateway” and then also enter the gateway IP address
and Use WAN Interface where packets will be sent to.
 Select “Use the following DNS server addresses” and then also enter the IP addresses of
Primary DNS server and Secondary DNS server.
 Click Next
The page of Network Address translation (NAT), IGMP multicast and MAC Clone settings will
show up and then WAN Setup Summary page will show up. Please refer related pages above
for reference. Click Save if correct and click Back to restart the configuration again.
Bridging
Figure 24: WAN Connection, Bridging Configuration