User's Manual

AR396 User’s Guide
22
To configure the Bridging settings:
 Check “Enable Bridge Service” to enable bridge service
 Enter the Service Name for this bridging interface.
 Click Next
The WAN Setup Summary page shows all of parameters. Click Save if correct and click Back
to restart the configuration again.
LAN
Figure 25: LAN Configuration
To configure LAN:
 Enter the IP address which the CPE in the LAN will use to connect to the device. For
example, enter 192.168.1.1
 Enter the Subnet Mask. For example, enter 255.255.255.0
 Check to enable UPnP feature
 Check to Enable IGMP Snooping. This feature will snoop all of IGMP packets and record