User's Manual

AR396 User’s Guide
23
related information. Therefore, multicast packets will be generated to the related LAN
ports only to avoid the packet flooding on all of LAN ports. Select one of two modes,
Standard mode or Blocking mode.
 Select to Enable or Disable DHCP server. If it is enabled, please enter the DHCP IP pool
of Start IP address and End IP address. Enter the value of leased time in hour about the
valid period of assigned IP address. The DHCP server ON (enabled) feature will enable
this device to assign IP address automatically to PC in LAN if PC requests an IP address
by DHCP client protocol.
 Click Add Entries button to add IP address excluded in the IP pool.
Figure 26: LAN DHCP Static IP Lease Configuration
 Enter the MAC address and static IP address which a dedicated PC uses this fixed IP
address already. This IP address will be excluded from the IP pool. Click Apply/Save to
save configuration.
 Check to Enable DHCP Server Relay and then input the IP address of DHCP server.
 The device can handle second IP address and subnet of LAN interface. You may check
this feature to configure the second IP address and subnet for LAN port to meet your LAN
environment.
 Click Save to save the configuration
Ethe rne t Mode
The Ethernet Mode feature provides to configure the connection speed of each Ethernet port
of switch. Besides, the connection status will be shown too.
Figure 27: Ethernet Mode Configuration
Global settings:
 Select the LAN port connection speed of each Ethernet port of switch from the list, AUTO,
100Full, 100Half, 10Full or 10Half. 100Full means 100Mbps full duplex and 100Half
means 100Mbps half duplex.
 Click Save to save the configuration