User's Manual
AR396 User’s Guide
28
Global Setting
Enter the Filter Name
Select the Protocol from the selection list.
Enter the Source IP Address and Subnet Mask (range of IP addresses) of packet
Enter the one port or multi ports (port range)
Enter the Destination IP Address and Subnet Mask (range of IP addresses) of packet
Enter the one port or multi ports (port range)
Click Save/Apply
By default, all incoming IP packets from WAN are blocked to access PCs in LAN, but some IP
packets can be accepted by setting up filters.
Figure 35: Incoming IP Filter Setup
Click Add to add a rule of Incoming IP Filtering.
Check Remove and click Remove to remove the specified entry.
Figure 36: Add - Incoming IP Filter Setup