User's Manual
AR396 User’s Guide
51
Global Setting
Set the AP mode as Access Point or Wireless Bridge
When the AP mode is set to Wireless Bridge, the Wireless Restrict determine where it can
communicate with all other wireless bridges (set Bridge Restrict is Disabled) or just the
specified MAC addresses of remote wireless bridge devices (set Bridge Restrict is Enable
or Enable (scan)).
Click Refresh to get the updated information
Click Save/Apply to save the configuration
Adva nc e d
This page allows you to configure advanced parameters for wireless communication.
Figure 78: Wireless Setting – Advanced
Global Setting
Enable AP Isolation if you do not want AP to be able to communicate with each other.
Set the Wireless Communication Band. If you do not know it, please it as default.
Select the channel from the list
Enter the value of Auto Channel Timer
Set the 54g Rate (Wireless Communication Rate), AUTO means to use the highest rate if
possible)
Set the Rate for Multicast Packets, AUTO means to use the highest if possible.
Set the Basic Rate
Set the Fragmentation Threshold values from 256 to 2364 bytes. If the value is too small,
it may cause a result in poor performance.
Set the RTS (Ready to Send) Threshold
Set DTIM Interval. DTIM stands for Delivery Traffic Indication Message. This is a beacon
and is a countdown informing wireless clients of the next window for listening to broadcast
and multicast messages. It is a wake-up interval for clients in power-saving mode.
Set Beacon Interval. The interval in milliseconds between beacon transmissions.