User's Manual

EG102 User’s Guide

Step 1. Connect the WAN port to the broadband device like DSL modem, cable

modem or fiber modem

Connect the WAN port to the broadband device like DSL modem, cable modem or

fiber modem which has the high speed internet connection.

Step 2. Connect the Ethernet cable

Connect up to four single Ethernet computers or to a HUB/Switch directly to the

device via Ethernet cable(s).

Note that the cables do not need to be crossover cables, the switch provides MDI and

MDIX auto-detection.

Step 3. Attach the power connector

Connect the AC power adapter to the Power connector on the back of the device and

plug the adapter into a wall outlet or power strip. Turn on and boot up your computer(s)

and any LAN devices such as hubs or switches.

Step 4. Configure your Ethernet PCs

You must also configure the Internet properties on your Ethernet PCs. See

Configuring Ethernet PCs section.

Or, step 5. Install a Wireless card and connect Wireless PCs if the device is with

wireless interface

You can attach a Wireless LAN that enables Wireless PCs to access the Internet via

the device.

You must configure your Wireless computer(s) in order to access your device. For

complete instructions, see Configuring Wireless PCs section.

Next step

After setting up and configuring the device and PCs, you can log on to the device by

following the instructions in “Getting Started with the Web pages” on chapter 4. The

chapter includes a section called Testing your Setup, which enables you to verify that

the device is working properly.