User's Manual

EG102 User’s Guide
22
LAN
Figure 22: LAN Configuration
To configure LAN:
 Enter the IP address which the CPE in the LAN will use to connect to the device.
For example, enter 192.168.1.1
 Enter the Subnet Mask. For example, enter 255.255.255.0
 Check to enable UPnP if necessary
 Check to Enable IGMP Snooping. This feature will snoop all of IGMP packets and
record related information. Therefore, multicast packets will be generated to the
related LAN ports only to avoid the packet flooding on all of LAN ports. Select
one of two modes, Standard mode or Blocking mode.
 Select to Enable or Diable DHCP server. If it is enabled, please enter the DHCP
IP pool of Start IP address and End IP address. Enter the value of leased time in
hour about the valid period of assigned IP address. The DHCP server ON
(enabled) feature will enable this device to assign IP address automatically to PC
in LAN if PC requests an IP address by DHCP client protocol.