User's Manual

EG102 User’s Guide
23
 Besides the dynamic assignment of IP address, you can configure the static IP
address too which will be reserved for the device with specified MAC address
only. Click Add Entries to enter MAC address of the device and fixed IP address.
You could check the entry and click Remove Entries to remove it.
 Check to enable and configure the second IP address and subnet mask for LAN
interface if there are two separated networks in the LAN sharing the device to
surf Internet. Then enter the second IP address and subnet mask.
 Click Save to save setting or Save/Reboot to save and then reboot the device
NAT (Ne two rk Ac c e ss Tra nsla tio n)
The NAT feature provides the basic firewall feature to avoid hacker attacks from
remote site. There are three more setting pages including virtual server, port trigger,
and DMZ to provide specified service for remote users.
Virtual Server
Virtual Server enables you to run a server on your local network that can be accessed
from the remote parties. You need to set up a rule to tell the device on which computer
the server is held. When port virtual server is enabled, your router (the device) routes
all the inbound traffic on a particular port to the chosen computer on your network.
Figure 23: Virtual Server Setup Configuration
Click Add to add a rule of virtual server.
Figure 24: Add A Rule Of Virtual Server