User's Manual

to list all parameters). Run ipconfig /release and then run ipconfig /renew.
IP address conflict
When you see the message box prompted for IP address conflict on any of the
workstations in the network, this means two or more workstations have the
same IP address. If you have setup the device as a DHCP server, on the
problem workstation, please run the “winipcfg”, utility, select the correct
Network Adapter, click release all to release all current configuration first, then
click renew all to renew the IP information again (for Windows 2000/NT4.0/XP,
run ipconfig/release and then run ipconfig /renew). If the DHCP function is
disabled and static IP addresses are assigned to each workstation, please
double check each workstation’s IP address for any duplicate IP.
Cannot access the Internet
 Check the physical connectivity of local network.
 Check if both the LEDs of local and Global on the product’s front panel are
lit. Make sure you are using the correct cables and the cables are
connected to the network devices properly.
 Check the physical connectivity of broadband device.
 Examine the LED of LAN port and the LED of the broadband signal input
on the Cable Modem/xDSL Modem. If the LAN LED is off, make sure you
are using the correct cables and the cables are connected to the devices
properly. If the LED of the broadband signal is off, please contact your ISP.
 Check the status of this product.
 After checking the cabling, you also have to check if you have entered the
correct user name and password that your ISP provided. While checking,
please note that the information is case sensitive.
 To check the Internet connection status, open the browser to start the web
configuration, select Network Status > WAN IP Status. Check if Link
Status displays “Connect successfully”. If not, you may have to contact
your ISP to see if their Internet service is available.
 Check the logical connectivity from your computer to the Internet.
Appendix D Government compliance notices
FCC compliance
This equipment complies with Part 15 of the FCC Rules. On this equipment is
a label that contains, among other information, the FCC registration number