Installation Manual

X16 Installation Guide - 52 -
Functions
Functions Features and LED function Feature Code Descriptive LED lit LED Not Lit Feature + 1
Record Active Not Recording
Feature + 2
Open N/A N/A
Feature + 3
Flash Key N/A N/A
Feature + 4
DND Active Not in DND
Feature + 5
Mute Active Not in Mute Mode
Feature + 6
Conference N/A N/A
Feature + 7
Pause N/A N/A
Feature + 8
Redial N/A N/A
Feature + 9
Headset Active Not Active
Feature + 0
All Page Active Not Active
Feature + *
Open N/A N/A
Feature + #
Open N/A N/A
Lamp (LED) Cadence Unlit Off Lit Lit Solid Fast 0.125 sec off, 0.125 sec on, repeating Slow 0.5 sec off, 0.5 sec on, repeating Wink 1 0.250 sec off, 1.750 sec on repeating. Wink 2 0.250 sec off, 0.250 sec on, 0.250 sec off, 1.25 sec on repeating Wink 3 0.250 sec off, 0.250 sec on, 0.250 sec off, 0.250 sec on, 0.250 sec off, 0.750
sec on, repeating.
Lamp (LED)s on Phone CO Line Status My Station Other Stations Idle Unlit Unlit In-Use Lit Green (I-Use) Lit Blue (In-Use) On Hold Slow Green (I-Hold) Lit Blue (In-Hold) Ringing Fast Blue Fast Blue Being Transferred Slow Green (I-Hold) Lit blue (I-Hold and Transfer) Intercom Tone cadences Dial Tone Continuous Tone Busy Tone 0.5 sec on, 0.5 sec off, repeating Ring Tone 1 sec on, 1 sec off, repeating DND Tone 0.25 sec on, 0.25 sec off, repeating
- 13 -
Installation
Installation The X16 comes standard with four RJ11 extension ports. Each port
supports up to 4 proprietary digital telephone endpoints, for a total of sixteen (16) endpoints. Each port on the system will support up to 600 feet of cable. In a star topology 600 feet is calculated by adding each Digital Telephone endpoints cable run. Cable A + Cable B + Cable C + Cable D <= 600 feet. In a serial cable topology 600 feet is calculated by adding the distance of the initial run plus the distance between each telephone. Cable A to telephone 1 + (distance between telephone1 & telephone 2) + (distance between telephone 2 & telephone 3) + (distance between telephone 3 & telephone 4) <= 600 feet.
Step 1 - Location The system should be located close to the telephone company interface (RJ21X), and have a dedicated outlet with an isolated ground. The system can be mounted on the wall or placed on a table. Once the location of the system is determined use the supplied wall mounting template to level and secure, the system, with the provided screws, or place it on a table.
CO Lines
Extensions
2 Line Expansion CO or VoIP Module