Installation Manual

X16 Installation Guide - 14 -
Installation
Lineup the back of the system with the four screws, and slides it into place. Step 2 – CO Line Connections Using the matrix below, connect the CO Lines to the system using one RJ14 connector per CO Line. The port labeled Line 1 is a direct access auxiliary port for line 1 allowing an analog device direct access.
Line Port Number AUX CO Line1 CO Line 1 1 / 2 CO Line 2 2 CO Line 3 3 / 4 CO Line 4 4 CO Line 5 5 CO Line 6 6
CO Lines
Extensions
2 Line Expansion CO or VoIP Module
L4 L3 L2 L1
A
UX CO
CO Lines
- 51 -
Ringing Scenarios
Ringing Scenarios Auto Attendant The Auto Attendant can be set to “On-AA Ring Only” or “Off-AllEXT Ring. Auto Attendant On-AA Ring Only When set to On-AA Ring Only, only the extension defined as the attendant (301 at default) will ring until the Auto Attendant Delay Timer expires. If the timer is set to 10 seconds, for example, the attendant extension will ring up to two times before the auto attendant answers. Auto Attendant Off-AllEXT Ring When set to Off-AllEXT Ring, all telephones programmed to ring, will ring until the Auto Attendant Delay Timer expires. Ringing Each extension may be programmed to ring or not ring, depending on the telephones programming. However, the Auto Attendant must be set to off-AllEXT Ring, to allow extensions to ring before the auto attendant answers the call. The telephones will ring unit the Auto Attendant Wait Timer expires, which can be set from 06 seconds to 240 seconds. Common Ringing Auto Attendant Delay - Set the Auto Attendant to Off-AllEXT Ring, and the Auto Attendant Wait Timer to 30 seconds and all telephones will ring for 30 seconds and then the line will be answered by the auto attendant. Auto Attendant Answering – Set the Auto Attendant to On-AA Ring Only, and set the Auto Attendant Wait timer to 10 seconds. Only the Attendant telephone will ring, for the length of the timer, and then the Auto Attendant Greeting will begin to play.