Installation Manual

X16 Installation Guide - 46 -
System Setup
Music Source – The system comes with an internal music on hold source, or can be connected to an external music on hold source such as a CD or MP3 player. CO MSGW – If this parameter is set to “On” and a Network (Telephone Company) voice mail system with Message Waiting Indication (MWI) is being used, then the display will show what lines have a new voice mail message. On the second line of the display it will show: CO MSGW: 12 4 6 – for lines 1, 2, 4 and 6. Clear CO MSGW – This will erase (clear) all of the Message Waiting Indication (MWI) left by the Network (Telephone Company) voicemail system. Area Codes – There are a total of 6 area codes that can be entered into the area code parameter. The first is the Home Area Code. This is the area code of the physical location of the system. When Caller ID is received, the 3 digits entered into the “Home Area Code” will not be displayed or redialed. The next five “Local Area” codes are used if the calling area requires ten (10) digit dialing. When Caller ID matches an entry, the number will be displayed and redialed with only 10 digits. When Caller ID does not match an entry in either the Home Area code or the local area codes, the system will display and redial the number with 11 digits.
AUTO MUTE
Music Source =External
AUTO MUTE
CO MSGW =Off
AUTO MUTE
Clear CO MSGW =No?
AUTO MUTE
Area Codes
Home Area Code Local Area C1 Local Area C2 Local Area C3 Local Area C4 Local Area C5
- 19 -
Expansion Module
Expansion Module The X16 system comes with four CO Lines and is expandable to six CO Lines. The two line expansion module can be either a CO Line module or a two channel VoIP Gateway Module. The expansion module mounts inside the communication server and connects to the main board, via ribbon cable. When the system is powered on, the expansion module will be recognized in software and fully operational. Use the following steps to install the expansion module. Step 1 – Installing the Expansion Module Place the voice server face down on a stable surface such as a table, showing the four rubber feet. Remove the four rubber feet, placing them in a safe place, such as the back of the voice server, exposing 4 screws. Unscrew the four screws and remove the cover.
2 CO Line Expansion Module
Phili
p
s Head Screws
Rubber Feet