Installation Manual

X16 Installation Guide - 38 -
Phone Setup
Preference Call – The user can select from accessing a CO Line or Intercom when going off hook. Line Selection – Each digital telephone endpoint user can set their telephone to directly access a CO Line or group of lines. Record all Calls – This parameter, when enabled, will record all network calls answered by this extension. When a call is placed on hold this timer starts. Each time this timer expires, a beep is heard to remind the extension user that a call is on hold. Extension users can program CO Lines to ring (on), or not ring (off), by pressing the up or down navigation key. Each CO Line can be programmed individually.
AUTO MUTE
Preference Call
AUTO MUTE
Line Selection
AUTO MUTE
Record All Call =Off
AUTO MUTE
Hold Reminder =30 Seconds
AUTO MUTE
Ringer On/Off
Line1 Ringer =On Line2 Ringer =On Line3 Ringer =On Line4 Ringer =On Line5 Ringer =On Line6 Ringer
- 27 -
Feature Description
Handset/Headset Volume Control The volume of the handset and headset can be adjusted to compensate for hearing levels. Press the volume + to increase or the volume- to decrease the
volume of the active status of the endpoint. For example, while speaking on the handset, the volume keys will adjust the handset volume.
Headset Activation Each digital telephone endpoint comes with a 1/8 inch (2.55 mm) standard “cellular” style telephone headset jack, which can be activated by dialing the feature code
Feature +
9. This feature code can be programmed on a button,
so that headset can be enabled and disabled as needed. In addition, a headset must be plugged in to enable headset mode. Note:
The voice quality and performance of headsets may vary
.
Hold Extension users may place Telephone Company central office line calls on hold allowing them to be picked up at other extensions. Hot Dial Pad Hot dial pad allows extension users to dial numbers without lifting the handset or pressing the speaker button. Intercom Calling Each extension is assigned a unique three digit code (number) ranging from 301 to 399. The number used as the time of registration becomes that extension’s intercom number. Dial the three digit code to intercom another extension. DSS/BLF buttons allows for one touch intercom calling. Intercom Paging Intercom paging is similar to intercom calling, but when the call is connected, the called party’s mute button is active. This allows the called party to have private conversations without being overheard. Line Status Detection (Line in Use) From Idle to Busy
– The system will detect if another device is using one of the
CO Lines and will automatically identify the line as busy.
From Busy to Idle
– The system will detect when the line is no longer busy, and
automatically identify the line as idle.