Specifications

Title: RF Protocol
Doc.#: XCT-RFP-EV100 (Rev. 1)
[CONFIDENTIAL]
Page 7 of 26
Enter the block address to set up protection.
- Available after authentication processing.
You can set the AUTH0 block data Write/Read Protect.
- (2) Can be used after authentication processing
- See the NTAG datasheet for more information.
You can view the current AUTH0 block address and Write/Read Protect settings
information.
- Available after authentication processing.
Reads the 24 Bit Counter value.
You can enable and disable the 24 Bit Counter. fi It can be used after authentication
processing.
You can decide whether to use it after authentication processing with 24 Bit Counter, or to
use it in general.
- (2) Can be used after authentication processing
24 Bit Counter Reads the current setup state.
Reads blocks in 4 bytes.