User's Manual
6 • Schlage • MT20 Enrollment Reader User Guide
Card Technologies Supported
Card Technologies Supported
125kHz Technologies
GE
®
/CASI
®
Proximity
HID
®
Proximity (except Long Format)
AWID
®
Proximity
LenelProx
®
13.56MHz Technologies
ISO14443 MIFARE DESFire EV1 with PACSA enabled (format in the card - up to 48 bits)
ISO14443 Secure MIFARE Classic:
XCeedID MIFARE app enabled (format in the card - up to 48 bits)
OESM (dormant - ready to be enabled by end-user)
ISO14443 PIV enabled 75-bit format (other formats available)
iClass/Inside UID enabled 40-bit format
ISO15693 UID enabled 40-bit format
ISO14443 UID disabled (can be enabled if PIV, EV1, and MIFARE are all disabled)
Felica CSN
aptiQmobile
Operational Behavior
Communication
The MT20 Reader can communicate over USB or BLE. USB is the preferred default communication channel.
Output
The USB connection uses Human Iinterface Device (HID) Keyboard Interface that requires the user to put the cursor in the desired
eld to receive the output. The default output of the enrollment reader will be Facility Code followed by Badge ID in a 9 digit form. If
you require a different output, please contact Allegion Technical Support at 1-877-671-7011, option 2.
RF Field
Every 100ms the RF eld turns on and the reader polls for cards. The 13.56 MHZ eld is on for approximately 42 ms in the
default reader conguration, which is maximum complexity. The 125 kHZ eld is on for approximately 20 ms in the default reader
conguration, which is maximum complexity.
Design References
ISO14443
ISO15963
OSDP Specication
Application Note Micore Reader IC Family from NXP Semiconductors - See XceedID website (www.allegion.com/us).
Design References
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.