User's Manual

INSTALLATION SHEET
XF1200S4/XF2200S4/XF2210S4
PARTS LIST:
• 1 - Installation Sheet
• 1 - Mounting Plate
• 1 - Potted Reader Assembly
• 1 - Cover
• 2 - Mounting Screws
• 1 – Cover Assembly Screw
Removal:
1. Remove unit from box.
Mounting the Reader:
1. Determine an appropriate mounting position on a single gang box or wall. Be sure to
account for any applicable ADA height requirements.
2. For a single gang box mount, attach the back-plate to the holes in the single gang box
using the screws provided.
3. For a wall mount, drill two mounting holes between 2.5” (63.5 mm) and 3.5” (88.9 mm)
apart on the mounting surface. Drill holes to make a hole on the wall about the same
size as the rectangular opening in the mounting plate (1.4” x .53” or 35.6 mm x 13.5 mm)
for the connector and cable wire connection to the host.
4. Connect the mounting plate to the wall using the screws provided.
5. Wire the unit according to the color code chart below ensuring that all connections are
made through the rectangular hole in the mounting plate.
6. Hook the top of the potted case assembly to the top of the mounting plate.
7. Swivel the unit down into place and snap the cover over the potted reader assembly.
8. Install the screw from the bottom to fix the cover to the potted case to the mounting
plate.
Cable Connections:
1. XceedID XF1200S4/XF2200S4/XF2210S4 readers are supplied with a 12 conductor
cable that contains a connector on one end and tinned wires on the other end. Connect
these wires to the host/panel being careful to match the color of each wire with the chart
shown below.
Green = Data 0 (Wiegand) / RS485A (F-Duplex)
White = Data 1 (Wiegand) / RS485B (F-Duplex)
Orange = Green LED
Brown = Red LED
Red = Power +DC (5-16 VDC)
Black = Ground
Tan = Tamper Output (Wiegand) / RS485Z (F-Duplex) / RS485B (H-Duplex)
Pink = Card Present (Wiegand) / RS485Y (F-Duplex) / RS485A (H-Duplex)
Yellow = Beeper
Gray = Not Used
Purple = Not Used
Blue = Not Used
2. Use a DC power source between 5 volts and 16 volts.
3. Be sure the reader is properly grounded by attaching the ground wire to an earth ground
connection at the power supply or panel end of the cable.
XceedID : Document No: 0469-01; Issue No. 1; 4/2/2008