Installation Guide

Xcluder Fill Fabric Installation Instructions
Xcluder Fill Fabric is designed to stop gnawing and burrowing pests from entering your house, apartment, mobile home
or building in a safe and environmentally responsive way. For preventing pest intrusion, Xcluder is superior and a
permanent solution for rodent control!
STEP 1: IDENTIFY IT
STEP 5: PACK IT
STEP 3: CUT IT
STEP 4: FIT IT
TOOLS NEEDED
750 West Lake Cook Road
Buffalo Grove, IL. 60089
Phone: [phone]
www.buyxcluder.com
U.S. Patent No. 6,919,117
Identify the gaps and spaces
where rodents can enter or
where there is evidence
rodents have entered.
Use sturdy, sharp scissors to cut a
piece of Xcluder that is slightly
larger than the opening (about
1½x to 2x the width of the
opening is usually sufficient).
Firmly place the Xcluder into the
opening. Be sure to fill the entire
opening, leaving no gaps or
spaces.
Using the blunt side of a
screwdriver, push the material into
the opening so that it is flush to,
or slightly below the surface of the
opening. Properly installed,
Xcluder will expand to form a
better seal shortly after
installation.
STEP 2: MEASURE IT
Measure the width and depth of
the space using a tape measure as
pictured or any other measuring
device.
Xcluder is made from coarse stainless steel wool, which has sharp edges. ALWAYS WEAR GLOVES AND USE CARE IN HANDLING AND CUTTING. AS
ALWAYS WITH ANY HOME IMPROVEMENT PROJECT, WHEN WORKING OVERHEAD USE SAFETY GLASSES TO PREVENT LOOSE FIBERS FROM
GETTING INTO THE EYES.
To contain loose fibers, always cut Xcluder over a trash receptacle. CUT XCLUDER BELOW EYE LEVEL.
Do not use Xcluder on surfaces that may exceed 270
o
F.
Do not use Xcluder in electrical enclosures or receptacles.
Xcluder Document # XCLINSTBULK Ver: 1.00 05.2013
Use for part #’s: 162743, 162746