Installation & Assembly

DO NOT RETURN TO RETAILER WHERE PURCHASED.
CONTACT XDP FOR PARTS AND SUPPORT AT 1.866.884.0535 or [e-mail]
4
INSPECTION PRIOR TO EACH USE OR DAILY INSPECTION
l DO NOT use the equipment if any bolts or nuts are missing or loose. ALWAYS check to ensure the
equipment and all parts are well secured and stable before each use.
l ALWAYS clear the play area of any rocks, sharp objects, or any materials that could be potentially hazardous
to users.
l DO NOT attach items to the equipment that are not specifically designed for use with the equipment, including,
but not limited to, jump ropes, clothesline, pet leashes, cables and chains as they may cause choke hazards.
l The steel and plastic parts used in your product are subject to normal wear. Gradual deterioration of the
material will occur, the speed of which will depend on the level of exposure to UV rays, airborne pollution,
outdoor weather conditions such as rain and wind and the amount of use. You must inspect the equipment
prior to every use. This includes, but is not limited to inspecting the set for cracks, excess wear, missing
parts, loose connections, and for overall integrity. When the set shows any signs of weakness, you must
stop using the play set immediately, properly store the set or restrict access by users until the condition is
resolved.
l Verify that the chains are secured at both ends and tightened, so that there is no loose chain hanging
that can result in choking hazard.
When conducting inspections, it is recommended that you use the Suggested General Maintenance
Checklist and Routine Inspection and Maintenance Issues checklists provided by the US Consumer Product
Safety Commission, a copy of which is contained in this user manual.
CARE & MAINTENANCE INSTRUCTIONS
l Inspect all nuts and bolts twice monthly during the usage season for tightness and tighten as required. It is
particularly important that this procedure is followed at the beginning of each season.
l Oil all metallic moving parts monthly during the usage period.
l Sand rusted areas on metal tubing and repaint using a nonlead-based paint meeting the requirements of
Title 16 CFR Part 1303.
l Check swing seats, stand n swing, and chains monthly during usage season for deterioration.
Replacements should be made in accordance with the manufacturer’s instructions.
l Check all coverings for bolts and sharp edges twice monthly during usage season to be certain that they
are in place and replace when necessary. It is especially important to do this at the beginning of each new
season.
l Do not use when the temperature drops below 32 degrees F (0 degrees C); remove and store the plastic
swing seats, stand n swing, and slide indoors.