User's Manual

6
Specifications
Width: 25 cm / 9,8 inches
Height: 25 cm / 9,8 inches
Length: 48 cm / 18,9 inches
Weight 17 kg / 37,5 lbs.
Voltage requirements: 110 V-240 V (Line frequency; 50 - 60 Hz, Max current: 2,3 A)
Support
To find technical support, contact the support team at [e-mail]
Warranty
The Xdrop™ instrument and associated accessories are covered by a standard Samplix ApS warranty.
Contact your local Samplix ApS office for the details of the warranty.
Safety
We strongly recommend that you follow the safety specifications listed in this section and throughout this
manual.
Xdrop™ is produced to comply with Safety Requirements for Electrical Equipment for Measurement, Control,
and Laboratory Use (UL 61010-1) and complies with EU (CISPR 11, class A, group 1, 150 kHz – 30 MHz) EMC.
This equipment has also been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
Environment and Power Requirements
Xdrop™ operating conditions are at temperatures 20-25°C, with a relative humidity (RH) 0-75%. Xdrop™
requires a stable power supply and can be powered using mains voltage of 100-240 VAC, 50-60 Hz. Main
power fuses (F3A, 250 V, 5x20mm) are located behind a small black plastic cover between main switch and
the power main plug at the back of the instrument. The Xdrop™ instrument must be installed on a flat surface
where access to the main power outlet is not restricted. The instrument is not to be used against the
manufacturers instructions. Failing to comply with the requirements can result in potential hazards to the
instrument and the user.