Operation Guide

Be sure to read this document carefully before using the product, to fully understand your legal
rights, responsibilities and safety instructions. Failure to do so, may cause property damage,
safety accidents and personal safety risks. Once this product is used, it is deemed that you have
understood, recognized and have accepted all the terms and conditions of this statement. The
user is responsible for all the consequences of his actions and consequences. The user agrees
to use the product for his sole & legal purpose, and agrees with the terms & conditions of this
agreement, and other relevant policies & guidelines that may be specied by XDynamics.
Under the maximum permission by law and approved circumstances, XDynamics is exempt
of liability for any indirect, punitive, consequential, special or criminal damages, including the
purchase cost, or for loss of income due to the loss of use of the drone.
XDynamics is exempt from the user’s liabilities for damage(s) to person/s or property,
or injuries incurred directly or indirectly from the use of this product in the following
conditions:
Damage(s) or injuries incurred when the user/s are under the inuence of alcohol, drugs
or medication.
Any malfunction caused by operators’ failure to follow the guidance of the manual to
assemble and set up, or operate the drone as described, and designed.
Damage(s) or injuries that may occur due to failure to study the tutorial videos, and the
user manual before ying the drone.
Damage(s) or injuries caused to a person/s or property, due to failure in correctly
calibrating the UAV as outlined in the manual, prior to ight. - Damage(s) or injuries
incurred as a result of the use or installation of any unauthorized third party accessories
or counterfeit parts - which were not provided and approved of by XDynamics.
Damage(s) or injuries as a result of ying the drone out of eyesight range, or more than
0.19mile ( 300m ) away from the controller.
XDynamics reserves all the rights for nal interpretation. This statement is effective at the
time of release, and it is subject to change, update and termination without prior notice.
FCC Compliance and Advisory
U.S. – FCC (Federal Communication Commission)
XDynamics Evolve FCC : 2ALI6XD-E2-EVOLVE
XDynamics Evolve Controller FCC : 2ALI6XD-G2-EVOLVE
This device complies with part 15 of FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modications that are not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC SAR statement (XDynamics Evolve Controller FCC : 2ALI6XD-G2-EVOLVE)
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user
must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves established by the
Federal Communications Commission (USA). These requirements set a SAR limit of 1.6 W/kg averaged over
one gram of tissue. The highest SAR value reported under this standard during product certification for use
when properly worn on the body.
P.3
FCC Radiation Exposure statement (XDynamics Evolve FCC : 2ALI6XD-E2-EVOLVE)
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator and
your body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.