User's Manual
Table Of Contents
- Declaration of Conformity (RED)
- User Manual 认证Remote
- WARNING
- This equipment complies with FCC radiation exposur
- Xencelabs Quick Keys Setup
- SECTION: Quick Keys Thank You
- SECTION: Quick Keys Navigation
- SECTION 1: Quick Keys Box Contents
- SECTION 2: Connecting the Xencelabs Quick Keys
- SECTION 3: Install the driver
- SECTION 4: Charging the Quick Keys
- SECTION 5: Key Features of the Quick Keys
- SECTION 6: Pairing the Quick Keys with the Tablet
- SECTION 7: Product registration
- SECTION 8: Tutorial videos
- SECTION 9: More Quick Keys Resources
SECTION 2: Connecting the Xencelabs Quick Keys
You can use the Xencelabs Quick Keys with a USB wired connection or over wireless. Note that
you should connect the tablet before trying to install the driver. If you bought the bundle, you
should also connect the Xencelabs Quick Keys before installing the driver.
Connecting the Xencelabs Quick Keys with a USB Cable
To use with a USB connection or to charge the Quick Keys, connect the provided USB cable to
the Quick Keys and to a USB-A port on a computer (Figure 1). You can connect it to a USB hub,
but it must be a powered hub. To charge the Quick Keys you need a USB port with at least 5
volts with 1.5 amps. It will take approx. 2 hours to fully charge.
When you connect the Quick Keys by USB and the computer is powered on, the Quick Keys will
turn on automatically.
Need graphic here
Need to update this for the Quick Keys
Connecting Wirelessly