Operation Manual

8
EN
2. After connection to the battery a load can be connected
to the output. Adjust the cable thickness to the output power
and the length.
3. Set the on/off switch to the ‘on’ position. The ‘power on’ LED
will light and there is a stable DC output voltage present.
Important
- The converter will not work (correctly) if the input voltage is
too low.
- If the converter isn’t used for a longer period of time, we
advise you to disconnect the converter from the battery.
‘External Control’ wire
The IPC and PB converters are equipped with a D+ wire, the
‘external control’ input. With this brown wire the converter can be
switched on/off on a distance. You can connect this wire for
instance on the D+ connection of the dynamo, the ignition key or
an external n/o switch. The converter will start operating when a
voltage will be connected to the D+ wire. If you want to use the
D+ wire in stead of the on/off switch, the on/off switch should be
set to the “off” position.
Connecting a battery on output
A battery may be connected on the output of the models from the
IPC and PB series. However, we advise you to order the charge
converter version of the concerning converter.
LED INDI CA TION S
Power on (green) - Output available
Battery low (yellow) - Battery voltage to low
Overload (red) - Overload/short circuit output