Installation Guide

12
• Switch to TEST mode to check that the light can illuminate even
during the daytime.
• Make sure battery is not drained and solar panel plug is fully
inserted.
• Make sure the battery plug is connected inside the battery
compartment.
• Set switch to OFF or AUTO mode and allow the solar panel to
absorb direct sunlight for two or more days to recharge the battery.
• Make sure there is no other brighter light source near the unit at
night time.
• Once battery is removed from the jacket. Make sure plug in the
solar panel charger or any other approved power adaptor after put
battery back to the jacket to reactivate.
The light will
not illuminate.
Symptom Possible Solution
Troubleshooting Tips.
• While in AUTO mode, if there is frequent activity from dusk to
dawn or consecutive overcast days, the solar panel may not
convert sufficient ambient daylight to recharge the battery.
• Reposition solar panel to receive more sunlight.
• Clean dust and debris from solar panel.
• Make sure the solar panel cable is not damaged.
• Check the motion detector to ensure that it is not directed towards
street traffic or where other movements may trigger the light
needlessly.
The battery
does not fully
charge.
The light stays
on continuously
while in AUTO
mode.