User's Manual

- The LED will change state from on to off for the duration of the button press.
- When the set is complete, the machine will cycle down, lower the stacker, and
unlock the front door.
- The LED will blink when the door is ready to open.
While the machine is cycled down:
- The LED will change state from off to on for the duration of the button press.
- The stacker will lower and the door will unlock.
- The LED will blink when the door is ready to open.
If the LED on the front door is blinking and the front door won’t open:
-Push the top left corner of the door closed.
-The magnet must be engaged for the door to open.
-Push the unload button again and the latch will release.
Unload while running a job:
If the Unload button is pushed while running a job, the system may run up to 100 sheets before
allowing the unload. If a jam occurs or the machine runs out of paper at this time, the jam must
be cleared or paper added to allow this to finish. The unload will not happen until these last
sheets are completed.
Note: The top cover and staple drawer can also be opened using the UI.
-Choose Printer
-Choose Unlock Finisher
-Choose top cover or staple drawer to unlock.
-The front door and staple drawer cannot be opened at the same time.
-Opening and closing the opened cover will allow the next cover to be opened.
The staple door won’t open:
- Open and close the top cover; remove any found paper.
Stack tray faults 12-2410 and 12-2415. (No longer requires restarting the system).
-Check that the front door is closed and the elevator tray is in.
-If fault persists, call for service.
39