User's Manual

Job ticket options
9-16 Guide to Printing Using Xerox Production Print Services
2. If you select [Custom], a Custom Selection dialog box
opens. Enter the name of the custom color, up to 30
characters, and select [OK] to close the Custom Selection
dialog box.
NOTE: If you are using a DocuPrint NPS printer, you may
enter a name of up to 27 characters. Do not use spaces
when entering the color name.
Specifying the stock type
Follow these steps to select the type of stock that you are
defining:
1. From the Type pop-up menu, select the stock type.
Depending on your printer, the following options may be
available:
• Standard: Opaque paper
• Transparency: Clear, plastic sheets (8.5 to 9 inches /
213 to 225 mm wide). This option usually may be
selected with any stock color; however, on some
systems, you may have to select [Clear] for the stock
color.
• Precut Tab: Paper stock on which tabs are cut in
incrementally spaced positions along the length of the
sheet, with one tab per sheet.
If you select this option, a Custom Selection dialog box
opens. Enter the desired number of tab positions, from
1 to 100, then select [OK] to close the Custom
Selection dialog box.
NOTE: An error will occur if 2-sided printing is
programmed for pre-cut tabs or drilled pre-cut tabs.
Printing on these stocks must only be 1-sided.
• Fullcut Tab: Stock on which tabs span the length of
one edge of the sheet.
• Preprinted: Stock on which a form, logo, etc., has
been printed previously.
• Custom: A stock type that is not on the Type menu.
The stock type name may have up to 30 characters.
Do not use spaces when entering the custom stock
type name.
If you select this option, a Custom Selection dialog box
opens. Enter a name for your custom stock type, then
select [OK] to close the Custom Selection dialog box.