User's Manual

Job ticket options
Guide to Printing Using Xerox Production Print Services 9-35
1. In the [Document] field on the XDS window, enter or
browse to locate and display the path to the document
that will be reprinted. If the save directory is the default
save location that was set at the DocuSP controller, then
entering a source directory path is not necessary. If a
source directory that is different from the default save
directory was selected, enter the directory path to the
save location.
NOTE: The source directory and file names are case
sensitive and must be identical to the name of the file that
was submitted to be saved. Note that some network
gateway software changes the case to all lowercase or all
uppercase.
2. Select the [Reprint] check box. A message appears,
informing you that the job ticket settings that were saved
with the job will be used.
3. In the message window, select [OK] to proceed with
reprinting.
4. Select [Setup].
5. Enter the job ticket parameters that you want to change
from the saved ticket parameters. For parameters that
you wish to keep the same as they were set in the saved
job ticket, either leave the parameters blank or set them to
[Printer Default].
NOTE: When [Reprint] is selected in the Xerox Document
Submission window, all of the job ticket parameters are
set to either the system defaults or to [Printer Default].
6. Select [OK].
7. Select [Print]. The job is sent to the printer for reprinting.
Checking the status of a job
To check the status of a job that has been sent to a Novell
print queue, use the Novell NetWare PCONSOLE utility. To
view the Novell print queue:
1. At the DOS prompt, enter PCONSOLE.
2. From the Available Options menu, select [Print Queue
Information], and press <Enter>. (You may not have
access to some of the options in PCONSOLE.)
3. Select the required print queue from the list that is
displayed, and press <Enter>. If only one print queue is
available, the print queue list is not displayed.