User's Manual

Using the XDS Plus software
3-8 Guide to Printing Using Xerox Production Print Services
Selecting a printer and queue
Follow these steps to select a printer and print queue for your
job:
1. On the XDS Plus window, select [Change Printer] to open
the Change Printer window.
2. If the queue that you want is not displayed in the [Queues]
section, select [Show All Queues].
3. In the [Queues] section, select the name of the queue to
which you want to send the job.
The Printers section displays the name of the printer that
is associated with the queue that you selected.
4. Select [Set Print Path] to confirm your selection and close
the Change Printer window.
NOTE: This can also be performed using the Printer menu
and select [Change Queue].
Printer and queue setup
NOTE: The printer discovery file must be set up on your
workstation before setting up the printer and queue. If the
printer discovery file was not added to your workstation
during installation, select the Preferences option from the
Options menu and add the printer discovery file.
NOTE: Refer to the Installation Guide for the procedure to
create a printer discovery file.
Printers and their queues for XDS Plus printing are set up
automatically when XDS Plus is installed and run. XDS Plus
detects all printing systems with DocuSP controllers running
DocuSP 3.X that are connected to your workstation. You
record the network addresses of these printers in a file called
“printer.disc,” after you install XDS Plus on your workstation.
When you select [Change Printer...] on the XDS Plus window,
the names of the printers that are listed in the printer
discovery file are displayed in the [Printers] section of the
Change Printer window and on the Print Monitor tab.