User's Manual

Printing a job using the DocuSP web interface
4-20 Guide to Printing Using Xerox Production Print Services
– A value of 100 prints the output to appear in all bright
colors.
– A value of 0 (zero) causes no change to the output.
NOTE: The output resulting from these selections may be
affected by the content of the original image.
Color Cast
In this section you can select a color cast that will be applied
to all input colors. You can adjust the following color ranges:
• Cyan – Red: -100 specifies the maximum cyan cast that
is supported by the system, and 100 specifies the
maximum red cast.
• Magenta – Green: -100 specifies the maximum magenta
cast that is supported by the system, and 100 specifies
the maximum green cast.
• Yellow – Blue: -100 specifies the maximum yellow cast
that is supported by the system, and 100 specifies the
maximum blue cast.
Setting Expert Color parameters
The Expert Color Settings window allows you to make
selections to enhance the color quality within your document
and to specify source color profiles and output color
parameters. To use the expert color fields, follow these steps:
1. On the Job Submission window, select [Expert Color] in
the [Color Features] section.
2. Make all desired changes and specifications in the fields
that are described in the following sections.
3. When finished making expert color selections, scroll to the
top of the Expert Color Settings window and do one of the
following:
• If you want to confirm your selections without closing
the Expert Color Settings window, select [Apply].
• Select [OK] to confirm your selections and close the
Expert Color Settings window.
• To close the window without making any changes,
select [Cancel].
The following sections describe the parameters that are
available on the Expert Color Settings window.