User's Manual

Using Command Line Client
6-2 Guide to Printing Using Xerox Production Print Services
Accessing XDS Command Line from Solaris and Mac OS X
Follow these steps to access XDS Command Line from
Solaris:
1. Log on to your network.
2. Use the main application called Print. Type Print -
<argument>. Additional information about using this
application is in the following section.
3. Wait for the XDSCL> prompt to appear on the window.
This may take several seconds.
At the XDSCL> prompt, you are now using XDS
Command Line in Multiple Command Mode and and may
enter job setup and print commands on the command line
at this prompt.
XDS Command Line operating modes
You can enter commands in the following mode:
• Print command mode: In this mode, you enter all the
specifications for setting up and printing a job as a single
command with multiple parameters.
You can key in commands and parameters at the XDSCL
prompt on the Java DOS window or the Unix Run window.
The command syntax differs for each mode.
NOTE: Unix commands are case-sensitive. Be sure to enter
each command exactly as it is represented in this chapter.
Using Print command mode
When operating in single command mode, you provide
instructions to XDS Command Line by entering one
command. All printing and job setup specifications that you
can enter are parameters of that one command. To access,
type the following:
Print -<argument.
Print command mode parameters
You can perform the following functions in print command
mode.