Installation Guide

Installation and configuration for Macintosh
Installation Guide 3-5
8. Select the Xerox Job Ticket PlugIn and drag the icon to
the Printer Descriptions folder.
9. If prompted to replace an older version, select [Ok].
10.Use the Desktop Printer Utility to set up and configure the
printers. Refer to “Configuring the printers,” later in this
chapter.
Configuring the printers
After installing the AdobePS driver, PPDs, and PlugIn, you
need to set up and configure the printers for your applications
and XDS.
1. In your workstation hard disk directory, open the Adobe
PS Components folder.
2. Open the Desktop Printer Utility. The New Desktop Printer
dialog box is displayed.
If the Desktop Printer Utility does not open to a new
printer dialog box, select [New] from the File pull-down
menu on the workstation menu bar.
3. From the With pull-down menu, select [AdobePS].
4. In the Create Desktop area, select either [Printer
(AppleTalk)] or [Printer (LPR)], depending on which
protocol your network is using. Select [OK].
5. In the [PostScript Printer Description (PPD) File] field,
select [Change].
6. Scroll to the bottom of the printer list, and select the
appropriate Xerox printer that you want to install.
7. Select [Select].
8. For AppleTalk, follow these steps:
a. Select [Change] in the [AppleTalk Printer Selection]
field.
b. Select the AppleTalk zone.
c. Select a PostScript printer from the displayed list of
available printers, then select [OK].
d. Select [Create].
e. If you want to rename the printer, enter the new name
in the [Name] field in the save dialog box that is
displayed.
f. Select [Desktop] to create the new printer on the
desktop, enter the printer name and select [Save].